Supporting frame in boxed stainless steel AISI 304 40x40mm thickness 2 mm. External coating in stainless steel AISI 304, thickness 20/10 with special pleatings to increase the mechanical resistance. Everything is painted in RAL 5010. Separate internal compartments: upper section holds electrical equipment and the terminal block for the attachment of the powercables, lower section is divided in 2 areas: one for the passage of the powercables and the other for the hydraulic piping and for the compressed air-conducts. Inside the water section there are, aside from the piping, also 2 water meters of class “B-H AV” in nickel brass with numerator for direct reading. On the external frame there are two taps of 1/2 inch, lockable by key, for the water distribution and two taps of 1/2 inch, lockable by key, for the distribution of compressed air. The frame has a canopy to protect the sockets against rain, under which two lamps are set controlled by a special crepuscular switch with external probe set on the structure itself. n°1 hinged hatch lockable by key for access to the above-indicated water section. n°1 hinged hatch lockable by key to access the switch board protected by special caps in unbreakable polycarbonate.
DIMENSIONS: 786x1503x535(LxHxW)mm ca.
ELECTRICAL DISTRIBUTION INPUT: through n°5 copper bars 40 x 8 mm, complete with n°2 hinges M8 (power-attachment and passing line, cables max. sections 240 mm2), set in the rear part of the structure, (section cable-access), nr.1 modular terminal block 2P 6mm2, (for the telephone line), and n°1 modular terminal block 2P 6mm2, (for the data-line).
GENERAL PANEL: circuit breaker 4P 250A with postponed rotating thermal adjustable movement (0,7-1xIn).
OUTPUT: n°2 sockets according the regulations CEE P17 400V 125A 3P+N+E (IP67), with electrical interlock, each one protected by a differential circuit breaker • 4P 125A, thermal adjustable (0,7-1xIn), adjustable sensibility and intervention time Idn 0,03-10A, t 0-3sec, each socket is equipped with a power meter to check the use of the two sockets. • n°1 socket according the regulations CEE P17 400V 63A 3P+N+E (IP67), with electrical interlock, protected by a differential circuit breaker 4P 63A intervention sensibility Id 0,3A. • n°2 sockets according the regulations CEE P17 230V 16A 2P+E (IP67), each one protected by a differential circuit breaker 1P+N 16A, intervention sensibility Id 0,03A. • n°4 sockets type BUCCANEER 2P 250V 10A equipped with screwcaps (IP67), used as: phone socket and data socket.
INSTRUMENTATION: • n°1 digital multimeter for the differential readings of the electrical volumes.
NOTE: The structure is equipped with: n°1 fluorescent lamp series BDTP-GIMAX 230V 9W IP67, inside the controlswitch board section, switching on is controlled at the opening of the hatch.
N.B. Further combinations are possible on request.
Via dell’Arabescato, snc
Zona Industriale Portone
55045 Pietrasanta (LU) - Italy